A lift table is specified by the working height band it must cover and the way the load sits on the platform.
The useful figure is the band between the lowest and highest working height your operators need: loading from a pallet at 150 mm, presenting to a conveyor at 800 mm, feeding a press at 1100 mm.
A table that only reaches the top of the band leaves the operator bending at the bottom of it, which is the part that causes the injury.
Load is not uniform. A point load in one corner, a pallet placed off-centre or a machine lowered onto the table all concentrate stress. State the heaviest single item and where it sits, not only the total load.
Platform size must include the pallet plus clearance for the forks of the truck that loads it.
Hydraulic power units are sized for a duty cycle, not only for the load. A table used every 20 seconds needs a different pump and cooling arrangement from one used twice an hour.
Confirm the supply voltage and control voltage for the destination; foot control, hand control and remote control change the safe operating position.
A lift table raises a load at a station and keeps it there. A stacker travels with the load and places it into racking. If the job is 'hold the pallet at working height', it is a table; if it is 'move the pallet and put it away', it is a stacker.
Models
Published figures for the first 8 models of this family; open a model page for the full specification.
Lift table selection guide model comparison
Questions
Size the table so the load can be brought to roughly elbow height for the tallest and shortest operator in the shift; that band is usually wider than buyers expect.
Yes, with a pit-mounted model. That is the usual choice where pallet trucks must roll on and off.
One set.
Send the load per move, the lift height and the floor surface. The sales desk matches the chassis to those figures and replies with a line-by-line offer.