Most pallet truck buyers start from the price and end up buying twice. Start instead from the load, the route and the floor — the three facts that decide the model.
A pallet truck is rated for the load it carries in one trip, at a stated load centre. A 2-tonne truck moved 300 pallets a day is still a 2-tonne truck; a 3-tonne pallet moved once a week still needs a 3-tonne rating.
Check the heaviest single pallet, then add margin for an unevenly stacked load. A pallet whose centre of gravity sits forward of the rated load centre effectively reduces the safe capacity.
Fork length must exceed the pallet depth so the load sits on the forks rather than on the tips. Euro pallets (1200 × 800 mm) and industrial pallets (1200 × 1000 mm) are entered from different sides, and block pallets need a wider fork spread than stringer pallets.
If the same truck must handle two pallet standards, choose the wider fork spread and the longer forks; a shorter fork cannot be extended later.
Polyurethane wheels suit sealed concrete and quiet floors; nylon wheels roll lighter but are noisy and less forgiving on joints; rubber wheels bridge small gaps and outdoor aprons. A truck pushed across a dock plate or a ramped threshold needs wheels that do not dig into the transition.
State the worst floor you will cross, not the best one. Epoxy-coated floors, expansion joints, gratings and kerbs all change the wheel choice.
Lead-acid is the lower-cost option and needs a ventilated charging area plus water topping. Lithium packs charge in shorter windows and can be opportunity-charged between shifts, which matters when one truck covers two shifts.
Confirm the destination voltage and plug standard before ordering: the charger is matched to the destination supply, not to the factory.
With those six answers the offer can name a specific model instead of a range, and the specification can be checked against your aisle before the container is booked.
Models
Published figures for the first 8 models of this family; open a model page for the full specification.
How to choose a pallet truck model comparison
Questions
Choose a 2-tonne rating rather than a 1.5-tonne rating: the extra margin covers uneven stacking, loads sitting forward of the load centre and floor transitions.
Yes, if the fork spread and length suit the wider standard. Specify the longer fork length and the wider spread at the order stage; they cannot be changed afterwards.
Usually not. Dock work involves ramps and dock plates, and manual trucks lose control on gradients. A powered-lift or fully electric truck is the safer choice.
One set. Mixed models can be combined in one container.
Many pallet truck models are held in ready stock; customised units are built in about 25 days.
Send the load per move, the lift height and the floor surface. The sales desk matches the chassis to those figures and replies with a line-by-line offer.