The rated capacity on the plate is a conditional number. Read the conditions before you compare two trucks.
Rated capacity is stated at a load centre — the horizontal distance from the fork face to the centre of gravity of the load — and at a reference lift height. A truck rated 3 tonnes at 500 mm load centre is not automatically a 3-tonne truck for a load sitting at 600 mm.
As the load centre moves forward, capacity falls. The derating is published as a curve or a table in the specification, and it is the number that matters for real loads.
Lifting higher reduces residual capacity on most trucks. If the rack beam is at 4.5 m, the figure to check is the capacity at that height, not the capacity at ground level.
Free-lift and full-free-lift masts matter in container and low-clearance work: without free lift, the inner mast starts rising immediately and can foul the container roof.
A forklift entering a container is limited by the door opening, the mast height when lowered and the overhead guard clearance. These three figures, not the capacity, usually decide whether a given model can work inside a container.
Models
Published figures for the first 8 models of this family; open a model page for the full specification.
Forklift capacity and load centre, explained model comparison
Questions
No. Capacity is rated at a stated load centre and reference lift height, and it derates as the load centre moves forward or the lift height increases.
Yes. An attachment adds weight at the fork and pushes the load centre forward, so the derated capacity must be checked before the attachment is ordered.
Diesel and LPG trucks with pneumatic tyres are the usual choice outdoors; electric trucks with solid tyres suit sealed indoor floors.
Send the load per move, the lift height and the floor surface. The sales desk matches the chassis to those figures and replies with a line-by-line offer.