Both lift pallets. The difference is how much floor they need and how high they can usefully go.
A stacker is a pedestrian or ride-on unit that lifts a pallet vertically, usually to rack beams up to a few metres. Its footprint is small, it needs little aisle width, and it costs less than a counterbalance truck of the same capacity.
Typical fit: low-level racking, picking faces, buffer storage, loading and unloading where the pallet stays in the same orientation.
A reach truck travels with the load close to the mast and reaches the fork forward into the rack. That combination gives high lift heights without the aisle width a counterbalance truck needs.
Typical fit: high-bay racking, narrow aisles, mixed pallet heights, and any layout where travel distance per put-away is long.
Many warehouses run stackers for the ground-level and picking work and one reach truck for the high bays. Splitting the fleet this way usually costs less than specifying every unit for the highest task.
If you are unsure, send the rack drawing with beam heights and the aisle widths; the reply can recommend a split rather than a single model.
Models
Published figures for the first 8 models of this family; open a model page for the full specification.
Electric stacker or reach truck? model comparison
Questions
It depends on the model's turning radius and the pallet depth, so the aisle width has to be checked against the specific unit rather than assumed.
Not always. Very narrow aisle layouts can use rail guidance, but a standard reach truck works in a wide aisle without rails.
One set, and stackers and reach trucks can share a container with other models.
Send the load per move, the lift height and the floor surface. The sales desk matches the chassis to those figures and replies with a line-by-line offer.