Drums are handled by the task — lift it, tip it, or move it — and each task has a different machine.
Steel, plastic and fibre drums of the same nominal volume behave differently: plastic drums can deform under a clamp, fibre drums need wider contact area, and steel drums can be held by a magnetic or clamp attachment.
Record the drum diameter, height, full weight and whether it is open-head or tight-head. A tight-head drum cannot be tipped without a pump or a tilted cradle.
A drum stacker must place the drum on a rack beam or a pallet at height; check the lift height and the mast clearance against the rack and the door.
Tipping over a vat or a mixer needs the drum's lip to clear the vessel rim, which is often the constraint rather than the drum weight.
A loaded drum is an unstable load. The machine must hold it against rotation, and the operator needs a clear zone around the tipping arc. For hazardous contents, secondary containment and grounding are process decisions, not equipment options.
Models
Published figures for the first 8 models of this family; open a model page for the full specification.
Drum handling equipment guide model comparison
Questions
Yes, a drum rotator does both, with a controlled tipping angle. A plain drum lifter only lifts.
Usually yes. Plastic drums deform under a clamp, so the clamp type and contact area have to suit the drum material.
One set.
Send the load per move, the lift height and the floor surface. The sales desk matches the chassis to those figures and replies with a line-by-line offer.