Unloading a 40-foot container by hand is a chain of lifts. A conveyor replaces the chain with a line.
Cartons at the far end of a container are carried roughly 12 metres to the door, one or two at a time, over a floor that is often above the dock level. The cost is labour time and lifting injuries, not the conveyor.
A telescopic conveyor extends into the container so the operator loads at the working face and the belt carries the carton out.
Specify the maximum extension needed to reach the back of the deepest container you unload, and the closed length that fits your storage and transport. A unit that extends far but cannot retract short will not fit a tight dock.
Boom extension, belt drive and height adjustment can each be manual or powered; powered units need the supply voltage confirmed for the destination. Variable speed and forward/reverse at the working face matter more than top speed.
Check the weight of the conveyor against the dock plate or floor it stands on, and the wheel brakes that stop it creeping while loaded.
Models
Published figures for the first 8 models of this family; open a model page for the full specification.
Container unloading equipment model comparison
Questions
It depends on carton weight and reach. Above roughly 5–6 metres of carry per item, the conveyor usually pays back in labour and injury cost within a year.
Yes, if the conveyor can be inclined and the cartons are suitable; a dock ramp or a leveler may also be needed to bridge the height step.
One set.
Send the load per move, the lift height and the floor surface. The sales desk matches the chassis to those figures and replies with a line-by-line offer.